Good evening, Pardon my ignorance, or my poor documentation reading skills, but I am unable to build Boost.Iostreams with compression filter support on Windows XP using MinGW. I am using Boost 1.34.1, zlib 1.2.3 and bzip2 1.0.4. I tried the following command lines but to no avail: bjam --toolset=gcc -sNO_COMPRESSION=0 -sNO_BZIP2=0 -sBZIP2_LIBPATH=C:\bzip2-1.0.4 -sBZIP2_SOURCE=C:\bzip2-1.0.4 -sNO_ZLIB=0 -sZLIB_LIBPATH=C:\zlib-1.2.3 -sZLIB_SOURCE=C:\zlib-1.2.3 stage or bjam --toolset=gcc --NO_COMPRESSION=0 --NO_BZIP2=0 --BZIP2_LIBPATH=C:\bzip2-1.0.4 --BZIP2_SOURCE=C:\bzip2-1.0.4 --NO_ZLIB=0 --ZLIB_LIBPATH=C:\zlib-1.2.3 --ZLIB_SOURCE=C:\zlib-1.2.3 stage I searched through the Boost.Iostreams documentation, the Boost.Jam documentation, and the Boost.Build V2 documentation. Boost.Jam documentation indicates that the former should work, but Boost.Build V2 seems to use very little of or not at all of the -s flag for Boost.Jam, so I tried the latter. The result of both commands were the same, Boost.Iostreams was built without the compression filters. However, I do get 12 "warning: Unable to construct ./stage-unversioned" as the first output from Boost.Jam, after which it says "...patience..." and continues with the building process. Thank you in advance for assisting me in my problem, and in case I have missed out something critical yet obvious, and hence resulting in my failure, I apologise for not reading carefully enough. Thank you and have a nice day Benjamin Lau