Marking explicit failures -- need help
Hi All, I would like to make some regression tests as expected to fail in explicit-failures-markup.xml, but I have the following problem. Not sure if this is specific to Optional tests: http://www.boost.org/development/tests/develop/developer/optional.html I have two "columns" with the same toolset label "gcc-4.4.7" from tester "Sandia". On one the test passes, on the other: it fails. This is because on one C++0x is enabled. But I cannot tell it from the toolset label alone, and therefore I cannot make the correct entry in failures-markup.xml: either I mark too much or too little. Does anyone know away around it? Can you mark failures based on something else than toolset name? Regards, Andrzej
2015-01-14 15:00 GMT+01:00 Andrzej Krzemienski
Hi All, I would like to make some regression tests as expected to fail in explicit-failures-markup.xml, but I have the following problem. Not sure if this is specific to Optional tests: http://www.boost.org/development/tests/develop/developer/optional.html
I have two "columns" with the same toolset label "gcc-4.4.7" from tester "Sandia". On one the test passes, on the other: it fails. This is because on one C++0x is enabled. But I cannot tell it from the toolset label alone, and therefore I cannot make the correct entry in failures-markup.xml: either I mark too much or too little.
Does anyone know away around it? Can you mark failures based on something else than toolset name?
Regards, Andrzej
Really, is it only me who is facing this problem?
participants (1)
-
Andrzej Krzemienski